KANOMAX 3910 Portable Particle Counter User Manual User Manual
Page 26
3. Display Description and Operation Procedure
18
[Measurement Settings]
Tap [SINGLE] to open the [MEASURE SETTING] dialogue box.
[SAMPLE T.] (Sampling Time).
Tap the entry field (a) to display a numeric
keypad.
Enter “hours”, “minutes” and “seconds” on the
numeric keypad and tap [OK] (b).
Check “AUTO SAVE” to store the data
automatically.
Check “AUTO PRINT” to print the data
automatically.
Check “START DELAY” to use a delay time
prior to a measurement.
Check “Set time” to set the time when you want to start a
measurement.
Tap [OK] (c) to save and activate the settings (Authentication
required).
[PRESET]
Tap [PRESET] (d) on “MEASURE SETTING” dialog box to display a window asking you to input
PRESET NAME.
Tap the entry field (e) to display the keyboard. Enter the file name and tap [Enter] (f).
Tap [OK] to save the current settings on the MMC card (Authentication required).
* In the future you can automatically load the configuration saved here as a PRESET. Refer to 3.5.6
PRESET.
(b)
(a)
(b)
(c)
(d)
(e)
(f)