KANOMAX 3910 Portable Particle Counter User Manual User Manual

Page 39

3. Display Description and Operation Procedure

Tap [STOP] to stop a measurement.

Tap button while measuring to
display a chart.

When a measurement at each measurement
point is finished, the measurement results
will be displayed.

Tap [NEXT] to display “CONFIRM” screen
which informs you of the next measurement
point then wait for the next measurement.

Tap [REMEASURE] to perform another
measurement at this measurement point.

Tap [PRINT] to print the measurement
results.

When all of the measurements are finished,
a final measurement result will be displayed.

You can view the results of a certain
LOCATION by selecting a Location from the
dropdown list of [Location].

Tap [CLOSE] to end the measurement.
Tap [REMEASURE] to perform a
measurement again at the last
measurement point.

Tap [PRINT] to print measurement results
of the last measurement point.

Every time you tap this button, the
particle unit changes in the order of:
p  p/cf  p/m³.

Use this button to select either
Total display or Single display.
(Only applicable for RAW DATA)