Lincoln Electric IM946 CRUISER Digital Tractor - Manual (Page 95)

Cruiser™ Tractor
OPERATION
10-18 10-18
Recall a Memory:
Press for 1 Second
Memories
WELD MODE SEARCHING
The Cruiser™ Tractor has four available memories. Each memory stores the following information:
• Weld mode
• Amperage (or WFS)
• Voltage
• Travel speed
• Frequency
Recalling a Memory with Memory Buttons
To recall a memory, press one of the four memory buttons. The memory is recalled when the button is released.
Do not hold the button for more than 2 seconds.
The Weld Mode Search feature allows the selection of a welding mode based on certain crite-
ria (wire size, process type, etc.).
SEARCHING FOR A WELD MODE
• To search for a mode, press and release the control knob while the WELD MODE indicator is lit. Another way
to search for a mode is to turn the control knob until “Weld Mode Search” is displayed. This will appear in be-
tween the highest and the lowest weld mode number.
• Once “Weld Mode Search” is displayed, pressing the right pushbutton labeled “Begin” will start the search
process.
• During the search process, pressing the right pushbutton typically acts as a “next” button and the left pushbut-
ton typically acts as a “back” button. Pressing the control knob also acts as a “next” button.
• Rotate the control knob then press to select relevant welding details such as welding process, wire type, wire
size, etc.
• When the final selection is made, the Cruiser™ Tractor will automatically change to the weld mode found by
the Weld Mode Search process.
• Earlier products may not have this feature. To activate this feature, a software update may be needed from
www.powerwavesoftware.com
Figure 10-6 Recalling a Memory with Memory Buttons
• Balance
• DC offset
• Arc start options
• Arc end options.