Lincoln Electric IM946 CRUISER Digital Tractor - Manual (Page 40)

Cruiser™ Tractor
ASSEMBLY
3-21 3-21
19. Remove rear outrigger bar and re-
verse it, so it is oriented the same
as the front outrigger bar
20. With the Cruiser™ tractor on a level
surface, the two guide wheels on
outrigger bars and the traction sur-
face of the fourth wheel mounted to
the horizontal cross tube should be
aligned, so all track evenly to a
plate perpendicular to the Cruiser™
tractor’s surface.
21. Mount the wire reel support assem-
bly to the long tube, so it is pointing
upward, and the clamp bracket is
toward the rear of the Cruiser™
tractor located about 9 inches (225
mm) from the right-hand end of the
long tube. Tighten the two bolts
using a 1/2-inch (13 mm) wrench.
22. Install one flux tube retaining ring.