Lincoln Electric IM946 CRUISER Digital Tractor - Manual (Page 55)

Cruiser™ Tractor
WIRE STRAIGHTENER ADJUSTMENT
6-2 6-2
1. Turn off power at the welding power
source.
2. Using a 1/4-inch hex key, loosen two
screws holding the wire straightener
clamps to the wire drive.
3. Rotate the wire straightener to add or
remove cast from the wire.
4. Tighten the screws holding the wire
straightener to the wire drive.
5. Turn on the power at the welding
power source.
6. Inch the wire through the wire drive.
Adjust the amount of pressure on the
wire until the desired cast is achieved
when the wire exits the contact tip.
Remove Cast Add Cast
Figure 6-1 Wire Straightener Cast