Lincoln Electric IM946 CRUISER Digital Tractor - Manual (Page 103)

Cruiser™ Tractor
OPERATION
10-26 10-26
Parameter Definition
P.12 Tractor Travel Speed
This option allows the adjustment of the Tractor Travel Speed for the Cruiser dX Tractor only. Press
the Right Button to enter the option and rotate the Control Knob to select Travel Speed. Press the
Right Button to enter the selected option. Rotate the Control Knob to select the desired value.
After selecting the value, press the Left Button to save the value and back out to select another
option. Rotate the Control Knob to make another selection, or press the Left Button to exit this op-
tion.
P.13 Arc Force Adjustment Options
This option allows the adjustment of Arc Force values for Start, Weld and Crater. Press the Right
Button to enter the option and rotate the Control Knob to select the desired weld state to adjust.
Press the Right Button again to adjust the value on the upper Left Knob. Press the Left Button to
save the value and back out to select another weld state. Rotate the Control Knob to make another
selection, or press the Left Button to exit this option. This option will not appear if the presently se-
lected weld mode does not support Arc Force.
P.14 Reset Consumable Weight
Use this option to reset the initial weight of the consumable package. Press the Right Button to
reset the consumable weight. This option will only appear with systems using Production Moni-
toring.
P.15 Hot-Inch Touch Sense Option
This option allows enabling or disabling touch sense when feeding wire forward.
Disabled = Touch sensing is disabled when feeding the wire forward (default).
Enabled = Touch sensing is active when feeding the wire forward.
When enabled and feeding wire forward, the wire is electrically "hot" and waiting to short to the
plate. When a short occurs, the wire feed automatically stops and the flux hopper relay is acti-
vated until the feed forward button is released.
P.18 Wire Drive Gear Ratio
This option selects the Wire Drive Gear Ratio that will be used. This applies to the Cruiser dX Trac-
tor and MAXsa 10 only. The possible selectable values are read from the Wire Drive on startup.
Note: Changing this value will cause the system to reset.
P.19 Wire Drive Direction
This option selects the direction that the Wire Drive will run in. This applies to the Cruiser dX Trac-
tor only. This option is useful since the Tractor's WD head can be rotated to "point" in different di-
rections.
P.21 Shutdown 2 Function Select
This option allows selection of the Shutdown 2 input function on the control box.
Normal Shutdown = The Shutdown 2 input functions as a standard shutdown input that locks out
all input buttons (default).
Output Disable = The Shutdown 2 input functions as a machine output lockout to disable the
welding circuit but still allow cold feeding of the wire.
P.80 Sense From Studs
Use this option for diagnostic purposes only. When power is cycled, this option is automatically
reset to False.
False = Voltage sensing is automatically determined by the selected weld mode and other machine
settings (default).
True = Voltage sensing is forced to "studs".
USER DEFINED PARAMETERS