Lincoln Electric IM946 CRUISER Digital Tractor - Manual (Page 49)

Cruiser™ Tractor
WHEEL CONFIGURATIONS
4-6 4-6
Joint Guide Wheels
The joint guide wheels work best for single pass butt or groove welds with
prepared edges.
1. Prop up or raise the Cruiser™ trac-
tor, so the front wheels are off the
ground.
2. Remove the front outrigger assem-
bly by removing two bolts using a
7/16-inch (11 mm) wrench.
3. Loosen two clamp bolts using a
1/2-inch (13 mm) wrench on each
front steering wheels. Slide the
steering wheels off of the tubes.