Lincoln Electric IM946 CRUISER Digital Tractor - Manual (Page 52)

Cruiser™ Tractor
WIRE GUIDES & DRIVE ROLL - REMOVE & INSTALL
5-1 5-1
Wire Guides and Drive Roll
Removal and Installation
Wire Guides and Drive Roll Removal and
Installation
1. Turn off the power at the welding power source.
2. If the flux hopper is mounted to the wire drive, remove one of the bolts
holding the flux hopper and swing the flux hopper out of the way.
3. Securely place a pry bar in the wire drive idle arm to relieve idle arm
pressure.
4. Using a 1/4-inch hex key, remove two screws holding wire straightener
clamps to the wire drive.
5. Remove the wire straightener and wire guide.
6. Using a 1/4-inch hex key, remove two screws holding the contact nozzle
to the wire drive.
7. Remove the contact nozzle and guide.
8. Using a 1-inch (25 mm) wrench,
remove the nut and washer holding the drive rolls in place. Remove the
drive rolls.