Lincoln Electric IM946 CRUISER Digital Tractor - Manual (Page 104)

Cruiser™ Tractor
OPERATION
10-27 10-27
Parameter Definition
P.99 Show Test Modes?
Most power sources contain weld modes used for calibration and test purposes. By default, the ma-
chine does not include test weld modes in the list of weld modes that are available to the opera-
tor. To manually select a test weld mode, set this option to "Yes". When the power source is turned
off and back on again, the test modes will no longer appear in the mode list. Test weld modes typ-
ically require the machine output to be connected to a grid load and cannot be used for welding.
P.100 View Diags?
Diagnostics are only used for servicing or troubleshooting the Power Wave system. Select "Yes"
to access the diagnostic options in the menu. Additional parameters will now appear in the setup
menu (P.101, P.102, etc).
P.101 View Event Logs
Used for viewing all the system event logs. Press the Right Button to enter the option. Rotate Con-
trol Knob to select the desired event log to read. Press the Right Button again to enter the selected
log. Rotating the Control Knob will scroll through the event log, displaying the log index number,
event code and some other data. Press the Left Button to back out to select another log. Press
the Left Button again to exit this option.
P.102 View Fatal Logs
Used for viewing all the system fatal logs. Press the Right Button to enter the option. Rotate Con-
trol Knob to select the desired fatal log to read. Press the Right Button again to enter that log. Ro-
tating the Control Knob will scroll through the log, displaying the log index number and fatal code.
Press the Left Button to back out to select another log. Press the Left Button again to exit this op-
tion.
P.103 View Software Version Info
Used for viewing the software versions for each board in the system. Press the Right Button to enter
the option. Rotate Control Knob to select the desired board to read. Press the Right Button again
to read the firmware version. Press the Left Button to back out to select another board. Rotate the
Control Knob to select another board, or press the Left Button to exit this option.
P.104 View Hardware Version Info
Used for viewing the hardware version for each board in the system. Press the Right Button to enter
the option. Rotate Control Knob to select the desired board to read. Press the Right Button again
to read the hardware version. Press the Left Button to back out to select another board. Press the
Left Button again to exit this option.
P.105 View Welding Software Info
Used for viewing the Weld Set in the Power Source. Press the Right Button to read the Weld Set
version. Press the Left Button to back out and exit this option.
P.106 View Ethernet IP Address
Used for viewing the IP address of Ethernet compatible equipment. Press the Right Button to read
the IP Address. Press the Left Button to back out and exit this option. The IP address cannot be
changed using this option
P.107 View Power Source Protocol
Used for viewing the type of power source the feeder is connected to. Press the Right Button to
identify the power source as either LincNet or ArcLink. Press the Left Button to back out and exit
this option.
USER DEFINED PARAMETERS (CONT.)