Yokogawa DAQWORX - Manual (Page 40)

2-29 IM WX11-01E
Creat
ng Mon
tor Screens w
th
AddObserver Bu
lder
1
2
3
4
Index
A value rectangle is created using the two corner points specified in steps 5 and 6.
7. Move the cursor to the channel you wish to assign to the value rectangle on the
channel page of the operation panel.
8. Drag the channel to the value rectangle.
(1) Drag the channel you wish to assign.
(2) Drop the channel plate on the value rectangle.
A value rectangle is created with the desired channel assigned to it.
Note
• When you drag a channel over a value rectangle, the cursor changes to a . If the cursor
changes to a , this indicates that the selected channel can not be assigned to the value
rectangle. Be sure to confirm whether or not a channel may be assigned.
• To remove channel assignments from value rectangles, see “Removing Channel or Alarm
Assignments from Objects” in section 2.30.
2.12 Creatng Value Rectangles