6 setting recording colors, Setting recording colors -14, Setup=color – Yokogawa DR240 User Manual
Page 175: 01:color=purple, Color set, Set up
10-14
IM DR232-01E
10.6 Setting Recording Colors
D I S P
M O D E
P R I N T
F U N C
I N S
D E L
R A N G E A L A R M
S E T
C H A R T
E N T E R
F E E D
M. F U N C 1
M. F U N C 2
RECORD
ALARM
CHART
KEYLOCK
R E C O R D
SETUP=COLOR
↓
D_INTG FILTER RELAY BURN_OUT RJC COLOR
↑
>Select Setting Parameter
E S C
• Enter the SET UP menu in the following procedure:
1. When the display presents the operation display mode or a menu other than the SET UP
menu, first turn off the power switch.
2. Turn the switch back on while pressing the DISP key and continue pressing the DISP key
for about 5 seconds.
• Select/set
using the
keys.
• If exiting the following lower menu setting halfway, press the MODE (ESC) key. The display
returns to the main menu to which the lower menu belongs. However, newly set or selected
contents are canceled.
• When setting proceeds to the display for the setting end, the newly set or selected contents are
established.
ENTER
ENTER
ESC
COLOR
001-01:COLOR=PURPLE
>Select Channel No.
001-01:COLOR=PURPLE
>Select Channel No.
001-01:COLOR=PURPLE
PURPLE RED GREEN BLUE BROWN
BLACK NAVY YEL_GR RED_PR ORANGE
***COLOR SET***
( M a i n m e n u )
( L o w e r m e n u )
SET UP=
Setting Recording Color
Set the recording colors for each channel. This setting can also be made for optional computation
channels.
• Select a color from the following ten colors:
PURPLE, RED, GREEN, BLUE, BROWN, BLACK, NAVY (navy blue), YEL_GR (yellowish
green), RED_PR (redish purple), and ORANGE
• The default setting is PURPLE for channel
1, RED for channel
2, GREEN for channel
3, BLUE for channel
4, BROWN for channel
5, BLACK for channel
6,
NAVY for channel
7, YEL_GR for channel
8, RED_PR for channel
9, and
ORANGE for channel 0.
Enter a unit number and a slot number in the two boxes
.
Note
• In order to make the set or selected contents effective, the contents must be registered. For details, see
page 10-23.
• To return from the SET UP menu to the operation display mode, select END in the main menu. For
details, see page 10-23.