Yokogawa DR240 - Manual (Page 153)

9-11 IM DR232-01E
9
Event/Action Function and Other Functions
• MATH (available if the instrument is equipped with the MATH function or floppy disk drive)
• START: Starts computation.
• STOP: Stops computation.
• RESET: Resets computation channel data at the end of completion of the first computation
in case an event takes place.
• CLEAR: Resets computation channel data immediately in case an event takes place.
• RST_G01 to RESET_G07: Resets the computing channel data registered in the specified
group number to 0. This is invalid for measuring channels. The timing for resetting the data
is as follows.
Reset here
Not reset
Computed value
Start computing Event
• If MATH is selected as a level action, computation will be carried out while an event is
present. Computation will stop when the event is cleared.
• MEMORY (available with the DR232-1/DR242-1 equipped with the floppy disk drive)
• DATA_WR: Saves a data item each time an event occurs, until the specified data length is
reached.
• WR_TRIG: Saves measured/computed data on the built-in RAM disk.
• RD_TRIG: Reads measured/computed data from the built-in RAM disk.
• LD_TRG1-3: Reads setup data from the built-in RAM disk.
• FLOPY (available only with the DR231-1 or DR241-1 equipped with a floppy disk drive)
• LD_TRG1-3: Reads setup data from the floppy disk.
• FLAG (only for /M1 optional model)
• F01 to 16: Set the flag number (F01 to F16) to 1. F01 to F16 are normally 0. Flags can be
placed in computing equations to hold the computed result using a certain event as a trigger,
or reset to 0.
• REPORT (available if the instrument is equiped with the REPORT function.)
• START (Edge action): Starts making up a report.
• STOP (Edge action): Stops making up a report.
• REPORT (Level action): Starts/stops making up a report.
Note
• If, in the SETUP mode, the report function is set to OFF for all data items, you cannot select the action
item REPORT.
9.1 Setting Event/Action Functions