Yokogawa DR240 - Manual (Page 135)

7-1 IM DR232-01E
7
Executing Recording
7.1 Starting Dot Printing, Digital Printing and
Printing in Logging Mode
D I S P M O D E
P R I N T F U N C
I N S D E L
R A N G E A L A R M
S E T C H A R T E N T E R
F E E D
M. F U N C 1
M. F U N C 2
ALARM
CHART
KEYLOCK
R E C O R D
E S C
RECORD
To start recording
Press the RECORD key. The status display [RECORD] lights.
To stop recording
Press the [RECORD] key once again. The status display [RECORD] turns off.
To feed the recording paper
Press the [FEED] key.
Starting dot printing, digital printing, and recording in logging mode
• See Chapter 6, “Setting.”
• Event/action functions can also be used to perform the above printing and recording (see Page
9-1).
Feeding the recording paper
Press the [FEED] key to feed the recording paper. Even if the [FEED] key is pressed while
recording, the paper is fed without stopping the recording.
Notes on starting recording
The carriage will stop temporarily at the left or right side for each line as shown below.
• When printing in logging mode or manual printing:
Printing direction Channel no./TAG selection Temporary stop (in seconds)
Horizontal Channel 4
TAG of 7 to 8 characters 3
TAG of 9 to 16 characters 5
Vertical Channel 2
TAG of 7 to 16 characters 3
• List printing
Temporary stop: For 0.5 secondsList printing