Yokogawa DR240 - Manual (Page 162)

10-1 IM DR232-01E
10
Basic Settings (SET UP)
10.1 Selecting Adjustment of Dot-Printing Position
or Scan Interval
D I S P M O D E
P R I N T F U N C
I N S D E L
R A N G E A L A R M
S E T C H A R T E N T E R
F E E D
M. F U N C 1
M. F U N C 2
RECORD
ALARM
CHART
KEYLOCK
R E C O R D
SETUP=PRN_ADJ
PRN_ADJ SCAN_INTVL RECORD ALARM A/D_IN ↑
>Select Setting Parameter
E S C
Recording Mode (SYSTEM)
• Enter the SET UP menu in the following procedure:
1. When the display presents the operation display mode or a menu other than the SET UP
menu, first turn off the power switch.
2. Turn the switch back on while pressing the DISP key and continue pressing the DISP key
for about 5 seconds.
• Select/set using the keys.
• If exiting the following lower menu setting halfway, press the MODE (ESC) key. The display
returns to the main menu to which the lower menu belongs. However, newly set or selected
contents are canceled.
• When setting proceeds to the display for the setting end, the newly set or selected contents are
established.
SET UP=
PRN ADJ
SCAN INTVL
PRINTER HYS=–_ _ _2
>Hys Limit(– 50~ 50)
PRINTER ZERO=_ _326
>Zero Limit (1~500)
PRINTER FULL=_2506
>Full Limit (2400~2600)
***PRINTER SET***
SCAN INTERVAL=0.5 (sec)
0.5 1 2 3 4 5 6 10 12 15 20 30 60
***SCAN INTVL SET***
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ESC
ESC
( M a i n m e n u )
( L o w e r m e n u )