IEI Integration WAFER-LX v1.0 - Manual (Page 110)

WAFER-LX
Disabled (D EFAULT ) ESCD will not be reconfigured
Enabled ESCD will be reconfigured after you exit setup
Resources Controlled By [Auto (ESCD)]
The Resources Controlled By option gives you the option of manually configuring all the boot
and plug and play devices, or allowing BIOS to configure these devices automatically. If you allow
BIOS to configure it automatically you will not be able to select the IRQs, DMA and memory base
address fields because BIOS will automatically assign them.
Auto(ESCD) (D EFAULT ) BIOS automatically configures plug and play devices as
well as boot devices.
Manual You manually configure the plug and play devices and
any other boot devices
x IRQ Resources [Press Enter]
If you select manual in the Resources Controlled By option then you will be able to configure the
IRQ Resources. To do this, select IRQ Resources and press E NTER . A new menu will appear.
(See BIOS Menu 15)
BIOS Menu 15: IRQ Resources
The menu will have the following 12 BIOS configuration options:
1. IRQ-3 assigned to
2. IRQ-4 assigned to
3. IRQ-5 assigned to
4. IRQ-6 assigned to
5. IRQ-7 assigned to
6. IRQ-8 assigned to
7. IRQ-9 assigned to
8. IRQ-10 assigned to
9. IRQ-11 assigned to
10. IRQ-12 assigned to
11. IRQ-13 assigned to
12. IRQ-14 assigned to
13. IRQ-15 assigned to
4-45 4-45