Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 46)

LabMaster 10 Zi Oscilloscopes
38
922561-00 Rev A
Miscellaneous Controls / WaveStream Indicator

Help - Opens the Teledyne LeCroy Online Assistant. If the second
monitor is installed, the online help opens on the second monitor.

Default Setup - Resets the oscilloscope's settings to the default
configuration. Corresponds with screen menu selection: File → Recall
Setup → Recall Default Setup.... For a list of default settings, see
Save/Recall → Saving and Recalling Setups (on page 140).

Auto Setup - Opens the Auto Setup... flyout menu.
Press the Auto Setup... button on the flyout menu to
perform a full auto setup. Press a Channel Find Scale
button on the flyout menu to perform a quick auto
setup for that channel only. Press the A
UTO S ETUP ... front panel
button twice to perform the last selection from the Auto Setup...
flyout menu (the default is to perform a full auto setup).
If Auto Setup is run when no channels are turned on, all channels are
affected. When more than one channel is turned on, the first channel
with a signal applied to it is automatically set up for edge triggering.

WaveStream - Indicates when WaveStream mode is ON.

Intensity - Toggles between WaveStream OFF and ON for Analog
Persistence and WaveStream ON for Color Persistence. When you
turn the knob, if WaveStream is ON, the WaveStream display
intensity changes. When you turn the knob, if WaveStream is OFF,
changes the Intensity setting. Corresponds with the screen menu
selection: Display → Display Setup (on page 95).