Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 115)

Getting Started Manual
922561-00 Rev A
107
Measurements
Parameters are measurement tools that determine a wide range of
waveform properties. Use them to automatically calculate many attributes
of your waveform, like rise-time, rms voltage, and peak-to-peak voltage.
There are parameter modes for the amplitude and time domains, custom
parameter groups, and parameters for pass and fail testing. You can make
common measurements on one or more waveforms simultaneously.
Turning On Measurements
1. Touch Measure → Measure Setup... on the menu bar.
2. Touch the On checkbox for each parameter you want to enable.
3. Touch the Show Table checkbox to display the parameters below the
grid.
Quick Access to Parameter Setup Dialogs
You can quickly gain access to a parameter setup dialog by touching the
parameter listbox in the table below the grid.
For example, touch within P1 to display the P1 setup dialog.
Touch the Measure column on the table display to show the main Measure
dialog.