Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 148)

LabMaster 10 Zi Oscilloscopes
140
922561-00 Rev A
Saving and Recalling Setups
The Save/Recall Setup dialogs allow for quick saving and recalling of up to
six oscilloscope panel settings internally on your instrument. If desired, you
can also save and recall your oscilloscope panel settings as an .lss file to a
specific hard disk location, a network location, or USB drive.
Saving Oscilloscope Setup(s)
Access the Save Setup... dialog by either selecting File → Save Setup... from
the menu bar or clicking the Save Instrument Setup button on the main
Save/Recall dialog. Now use one of the following two methods to save
setup(s).
S AVE S ETUP ( S ) I NTERNALLY ON Y OUR I NSTRUMENT
1. Touch inside one of the six SetupX data entry controls in the Save to
Internal Setup... section and providing a name.
2. Touch its corresponding Save button directly to the left.
Your setup file is then saved to the D:\Internal Setups location on your
instrument and the current date/time is shown above the SetupX data entry
control.
S
AVE
S
ETUP
(
S
) D
IRECTLY TO A
F
ILE
1. Touch the File button on the Save To section on the dialog.
2. Touch inside the Save files in directory control and provide a path to
the destination folder.
OR
Touch Browse to navigate to the destination folder.
3. Touch the Save Now button.