Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 131)

Getting Started Manual
922561-00 Rev A
123
Pass/Fail Condition Setup on Qx Dialogs
The Qx dialog contains several controls for specifying your Pass/Fail
conditions.
M
AIN
Q X D
IALOG
C
ONTROLS
Use the Source1 control to specify the waveform you'll use for your
Condition.
Set your Pass/Fail condition by touching the Condition control on the
corresponding Qx dialog. The Pass/Fail Condition pop-up is shown. Select
the desired condition.
NOTE : Right-hand dialogs on the Qx dialog vary based on the Pass/Fail condition
selected.
C ONDITION -B ASED R IGHT -H AND D IALOGS
Boolean Identity
This condition simply passes through the input values as the desired result.
Param and Dual Param Compare