Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 105)

Getting Started Manual
922561-00 Rev A
97
Dual Display Grid Selection
Make a dual grid display selection for showing on an external display (once
properly connected to the I/O panel) by selecting Display → Display
Setup.... Numbered labels on this image correspond with the following
steps.
NOTE : First-time setup may show a different Display tab. Fix this by touching File
→ Exit on the menu bar and re-launching the oscilloscope software using the Start
DSO shortcut on the desktop.
1. Touch the Dual button on the Display Mode section of the Display
dialog.
2. Touch inside the Grid control on the Grid Mode section of the dialog.
The Select Grid pop-up is shown.
3. Touch the Dual Display category and choose from Single/Single,
Dual/Dual, and Quad/Quad options.
Your grid selection is now shown on both displays.
Persistence
Persistence Overview
The Persistence feature helps you display your waveform and reveal its
idiosyncrasies or anomalies for a repetitive signal. Use Persistence to
accumulate on-screen points from many acquisitions to see your signal
change over time. The instrument persistence modes show the most
frequent signal path in three-dimensional intensities of the same color, or
graded in a spectrum of colors.
You can show persistence for up to eight inputs for any channel, math
function, or memory location (M1 to M4).
Persistence Setup
Choose Display → Persistence Setup... from the menu bar, then touch the
Persistence On checkbox.