Teledyne LeCroy LabMaster 10Zi Operators Manual User Manual
Page 14
LabMaster 10 Zi Oscilloscopes
6
922561-00 Rev A
WARNING. Interrupting the protective conductor inside or outside
the oscilloscope, or disconnecting the safety ground terminal, creates
a hazardous situation. Intentional interruption is prohibited.
CAUTION Do not place the instrument so that it is difficult to reach
the power cord inlet to disconnect the instrument.
Standby Power
The Standby (Power) button on the MCM-Zi Master Control Module
controls the operational state of the oscilloscope.
Press the button to switch the instrument into Standby mode
(reduced power); press it again to return to full operation.
Press and hold the button for 5 seconds to power off the
instrument.
The LED symbol below the Standby button indicates the operational state of
the oscilloscope:
Blue – fully powered and operational.
Off – powered off except for some housekeeping circuits.
Always use the Standby button or the File > Shutdown menu option to
execute a proper shut down process and preserve settings before powering
down.
Do not shut down by pulling the power cord from the socket or
shutting off a connected power strip.
The Standby button does not disconnect the oscilloscope from the AC
power supply. The only way to fully power down the instrument is to unplug
the AC power cord from the outlet.
We recommend unplugging the instrument if it will be unused for a long
period of time.
CAUTION.
Do not change the instrument’s Windows Power Options
setting from the default Never to System Standby or System
Hibernate. Doing so can cause the system to fail.