IAI America E-Con - Manual (Page 91)

77
Code Error Cause/action
0CA Overheat The surrounding air temperature of the power transistor in the controller
rose excessively (to 95
C or above).
Cause: [1] High surrounding air temperature of the controller
[2] Defective internal part of the controller
Action: [1] Lower the surrounding air temperature of the controller.
If the surrounding air temperature is normal, please contact IAI.
0CC Abnormal control power voltage The voltage of the 24-V input power supply dropped (by 20% or more, or
to 19.2 V or below).
Cause:
[1] Low voltage of the 24-V input power supply
[2] Faulty internal part of the controller
Action: Check the voltage of the input power-supply.
If the voltage is normal, please contact IAI.
0DC Out of push operation range The actuator was “pushed back” during push-motion operation in the
push mode.
Cause:
Strong external force is applied to the work part.
Action: Revise the mechanism around the work part so that strong
external force will not apply to the work part.
Or, increase the current limit value.
0E0 Overload Cause: [1] The load increased due to external force.
[2] The brake cannot be released on the actuator with brake.
[3] The slide resistance of the actuator increased locally.
Action: [1] Review the area around the work part. If abnormal external
force is being applied, correct the situation.
[2] Turn on the break release switch to check if the break will
be released. If the brake is not released, a faulty brake,
open cable, or defective brake circuit part in the controller is
suspected.
[3] Move the controller by hand, if possible, to check for points
where large slide resistance is felt.
In the case of [2] or [3], please contact IAI.
Note:
Before resuming the operation, always remove the cause of
the alarm. If the controller power was turned off, wait for at
least 30 minutes before turning on the power to protect the
motor coil from burn damage.