Fairbanks FB6002 INSTRUMENTATION - Manual (Page 71)

01/13 71 51293 Rev. 2
Section 7: Accessories
7.1. PROGRAMMING THE TRAFFIC LIGHT CONTROL
The Traffic Light Control shows the status of the scale’s traffic light. It is typically
controlled automatically by the instrument weighment cycle.
•
Each I/O RELAY CARD supports two (2) sets of lights.
7.1.1. Traffic Light Control
Follow these steps to setup the Traffic Light Control.
1. In the Configuration Menu, press the down arrow until TRAFFIC TRAFFIC TRAFFIC TRAFFIC LIGHT LIGHT LIGHT LIGHT
CONTROL CONTROL CONTROL CONTROL displays.
2. Press ENTER.
3. When SCALE SCALE SCALE SCALE ID ID ID ID 1 1 1 1 displays, either press ENTER.
4. When CONTROL CONTROL CONTROL CONTROL TRAFFIC TRAFFIC TRAFFIC TRAFFIC LIGHT LIGHT LIGHT LIGHT displays, press ENTER.
5. When AUTOMATIC AUTOMATIC AUTOMATIC AUTOMATIC displays, either press ENTER to select it, or press the
down arrow to enter the MANUAL MANUAL MANUAL MANUAL option.
6. Press ENTER.