Fairbanks FB6002 INSTRUMENTATION - Manual (Page 52)

Section 6: Serial Input / Output
01/13 52 51293 Rev. 2
6.2. PROGRAMMING THE COM PORTS
NOTE: Always configure the Printer before formatting the tickets.
Follow these steps to program the four (4) COM Ports.
1. In the Configuration Menu, press the down arrow until COM PORTS COM PORTS COM PORTS COM PORTS
displays.
2. Press ENTER .
3. Using the down arrows, select the correct COM PORT COM PORT COM PORT COM PORT to configure, then
press ENTER .
– COM Ports one thru three (1-3) are standard analog ports.
– COM Port four (4) is dedicated to 20 mA Output, currently used for the
Remote Display.
▪ The wires for is device feed through the Gland Nut located on the Instrument’s
back wall, then attach to
TERMINAL J4
(see image below).