Important installation notice – Fairbanks FB6002 INSTRUMENTATION User Manual
Page 11

Section 1: General Information
01/13
11
51293 Rev. 2
IMPORTANT INSTALLATION NOTICE
•
All load cells, load cell cables and interconnecting cables used to connect all
scale components shall be located
a minimum of thirty-six (36”) inches
distance away
from all single and multiple phase high energy circuits and
electric current carrying conductors.
– This includes digital weight Instruments, junction boxes, sectional controllers,
and power supplies.
– This includes any peripheral devices, such as printers, remote displays, relay
boxes, remote terminals, card readers, and auxiliary data entry devices.
– Also included is the scale components themselves, such as 120 volt AC, 240
volt AC, 480 volt AC and electric supply of higher voltage wiring runs and
stations, AC power transformers, overhead or buried cables, electric
distribution panels, electric motors, florescent and high intensity lighting which
utilize ballast assemblies, electric heating equipment, traffic light wiring and
power, and relay boxes.
•
All scale components, including digital weight Instruments and peripheral devices
are not designed to operate on internal combustion engine driven electric
generators and other similar equipment.
•
Electric arc welding can severely damage scale components such as digital
weight Instruments, junction boxes, sectional controllers, power supplies, and
load cells.
NOTE:
For additional information, please contact a
Fairbanks Scales Service
Representative.