Avaya Wireless AP-3 - Manual (Page 322)

Configuring the AP using CLI commands
A-36 Avaya Wireless AP-3 User’s Guide
Configuring the AP using CLI commands
Log into the AP using HyperTerminal
1. Open your terminal emulation program (like HyperTerminal) and
set the following connection properties:
— Com Port:
— Baud rate: 9600
— Data Bits: 8
— Stop bits: 1
— Flow Control: None
— Parity: None
2. Under File -> Properties -> Settings -> ASCII Setup, enable the
Send line ends with line feeds option.
Result: HyperTerminal sends a line return at the end of each line
of code.
3. Enter the CLI password (default is public).
NOTE:
Avaya recommends changing your default passwords immediately.
To perform this operation using CLI commands, refer to
Change
Passwords .