Avaya Wireless AP-3 User Manual
Page 283
Recovery Procedures
7-28 Avaya Wireless AP-3 User’s Guide
Follow these steps to assign the AP an IP address:
1. Open your terminal emulation program (like HyperTerminal) and
set the following connection properties:
— Com Port:
— Baud rate: 9600
— Data Bits: 8
— Stop bits: 1
— Flow Control: None
— Parity: None
2. Under File -> Properties -> Settings -> ASCII Setup, enable the
Send line ends with line feeds option.
Result: HyperTerminal sends a line return at the end of each line of
code.
3. Press the RESET button on the AP (see
to identify the location of the RESET button).
Result: The terminal display shows Power On Self Tests (POST)
activity, and then displays a CLI prompt, similar to the example
below. This process may take up to 90 seconds.
[Device name]>
Please enter password:
4. Enter the CLI password (default is public).
Result: The terminal displays a welcome message and then the
CLI Prompt:
[Device name]
>