Avaya Wireless AP-3 - Manual (Page 285)

Related Applications
7-30 Avaya Wireless AP-3 User’s Guide
7. After the AP reboots, verify the new IP address by reconnecting to
the CLI and enter a show ip command. Alternatively, you can ping
the AP from a network computer to confirm that the new IP
address has taken effect.
8. When the proper IP address is set, use the HTTP interface or CLI
over Telnet to configure the rest of the unit’s operating parameters.
Related Applications
RADIUS Authentication Server
If you enabled RADIUS Authentication on the AP, make sure that your
network’s RADIUS servers are operational. Otherwise, clients will not be
able to log in. There are several reasons the authentication server
services might be unavailable, here are two typical things to check:
• Make sure you have the proper RADIUS authentication server
information setup configured in the AP. Check the RADIUS
Authentication Server’s Shared Secret and Destination Port number
(default is 1812; for RADIUS Accounting, the default is 1813).
• Make sure the RADIUS authentication server RAS setup matches
the AP.