Parameter control commands, Show” cli command – Avaya Wireless AP-3 User Manual
Page 309
CLI Command Types
Avaya Wireless AP-3 User’s Guide A-23
Parameter Control Commands
The following sections cover the two Parameter Control Commands
(show and set) and include several tables showing parameter properties.
These commands allow you to view (show) all parameters and statistics
and to change (set) parameters.
• show: To see any Parameter or Statistic value, you can specify a
single parameter, a Group, or a Table.
• set: Use this CLI Command to change parameter values. You can
use a single CLI statement to modify Tables, or you can modify each
parameter separately.
“show” CLI Command
Displays the value of the specified parameter, or displays all parameter
values of a specified group (parameter table). Groups contain Parameters
and Tables. Tables contain parameters for a series of similar entities.
To see a definition and syntax example, type only show and then press
the Enter key. To see a list of available parameters, enter a question
mark (?) after show (example: show ?).
Syntax: