Avaya Wireless AP-3 - Manual (Page 221)

VLAN/SSID
Avaya Wireless AP-3 User’s Guide 4-133
NOTE:
For Dual-radio APs: APs with an 11a Upgrade Kit or 802.11b/g Kit
support up to 16 VLAN/SSID pairs. APs with an 802.11b PC Card or
a 5 GHz Upgrade Kit support only one VLAN/SSID per radio.
The four primary scenarios for using VLAN workgroups are as follows:
Configure Multiple VLAN/SSID Pairs
NOTE:
You must reboot the AP before any changes to these parameters
take effect.
1. Click Configure > VLAN.
2. Place a check mark in the Enable VLAN Protocol box to enable
VLAN support.
3. Click the tab for Wireless A or Wireless B (if applicable).
VLAN disabled: Your network does not use VLANs, but you
can configure the AP to use multiple SSIDs.
VLAN enabled, all VLAN Workgroups use the same VLAN ID
Tag
VLAN enabled, each VLAN workgroup uses a different VLAN
ID Tag
VLAN enabled, a mixture of Tagged and Untagged workgroups