Set” and “show” command examples – Avaya Wireless AP-3 User Manual

Page 313

Text mode
Original mode

CLI Command Types

Avaya Wireless AP-3 User’s Guide A-27

“set” and “show” Command Examples

In general, you will use the CLI show Command to view current
parameter values and use the CLI set Command to change parameter
values. As shown in the following examples, parameters may be set
individually or all parameters for a given table can be set with a single
statement.

Example 1 - Set the Access Point IP Address Parameter

Syntax:

[Device Name]>set

Example:

[Device Name]>

set ipaddr 10.0.0.12

Result: IP Address will be changed when you reboot the
Access Point. The CLI reminds you when rebooting is required for
a change to take effect. To reboot immediately, enter reboot 0
(zero) at the CLI prompt.