GF Signet 9900-1BC Batch Controller System - Manual (Page 26)

26 9900-1BC Batch Controller Manual
Relay Specifi cations
Hysteresis
Adjustable (absolute in
Engineering Units)
Latch Reset in test screen or
View Mode
On Delay 9999.9 seconds (max)
Test Mode Set On or Off
Maximum pulse rate: 400 pulses/minute
Volumetric Pulse Width: 0.1 s to 3200 s
Open Collector
Type:
NPN
Max. Voltage Rating: 30 VDC
Max. Current Rating: 50 mA
Dry-Contact Relays
Type:
SPDT
Form: C
Max. Voltage Rating: 30 VDC or 250 VAC
Max. Current Rating: 5 A
Shipping Weights
Base Unit
0.63 kg (1.38 lb)
Batch Module 0.16 kg (0.35 lb)
Relay Module 0.19 kg (0.41 lb)
Standards and Approvals
CE, UL, CUL
China RoHS (visit gfsignet.com for details)
This device complies with Part 15 of the FCC
rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
RoHS compliant
Manufactured under ISO 9001 for Quality,
ISO 14001 for Environmental Management and
OHSAS 18001 for Occupational Health and Safety.
Electrical Requirements
Power to Sensors:
Voltage:
+4.9 to 5.5 VDC @
25 °C, regulated
Current: 20 mA
Short Circuit Protected
Terminal Blocks
• Pluggable screw type
• 14 AWG max wire gauge
Input Power Requirements
DC (preferred)
24 VDC Input;
range: 10.8 to
35.2 VDC regulated
300 mA maximum
Overvoltage protection 48 Volt Transient
Protection Device
Current limiting for circuit protection
Reverse-Voltage protection
Loop Characteristics
With DC power input (preferred)
Max. loop impedance
@ 12 V loop power 250 Ω max.
@ 18 V loop power 500 Ω max.
@ 24 V loop power 750 Ω max.
Specifi cations