GF Signet 9900-1BC Batch Controller System - Manual (Page 16)

16 9900-1BC Batch Controller Manual
VIEW Mode Menu - Batch Stopped
Start Batch Press Up or Down arrows to select the desired batch number.
Press ENTER to start selected batch. Selected batch alternately displays on the bottom line of the display.
(Confi rmation screen or password screen are user-selectable in INPUT menu.)
Available batches determined by the number of stored batches whose size is not zero.
Resume/Cancel Batch Displays when a batch is stopped without completing. Press the ► key to select
either RESUME or CANCEL and then press ENTER to either resume the batch or cancel it. A confi rmation
or password screen for resuming a batch is user selectable. This screen will not display if the batch
reaches completion.
Override Batch occurs when the user temporarily changes a batch size in View Mode. The change is
temporary and is only active until a batch is run. After any batch is run, an overridden batch reverts back
to its stored size. Only one batch can be overridden at a time. If the user overrides a second batch, the
fi rst overridden batch will revert to its stored size. The batch name will display OVERRIDE while it is
overridden. A batch is overriden by pressing ► to edit the batch size.
Manual Batch is used for “topping off” a batch. The Batch Controller will open the valve as long as the
user simultaneously holds down the ▼ and ► keys.
Note: A manual batch will cancel a batch in the RESUME/CANCEL state.
Source Volume shows the calculated remaining source volume. Displays if SOURCE VOLUME is ON.
Reset source volume with ► key.
Note:
If PWD REQUIRED is set to YES, you may be prompted to enter your password. PWD REQUIRED
setting can be changed in the OPTIONS menu.
Reset Volume? Confi rmation screen for resetting SOURCE VOLUME. Press ▲ or ▼ to select YES and
press ENTER to reset source volume.
Resettable Totalizer displays the resettable totalizer. Press ► to reset the totalizer. Note: If PWD
REQUIRED is set to YES, you may be prompted to enter your password. PWD REQUIRED setting can be
changed in the OPTIONS menu.
Reset Total? Confi rmation screen for clearing the resettable Totalizer. Press ▲ or ▼ to select YES and
press ENTER.
Permanent Totalizer displays the Permanent Totalizer value (note the "P" indicating Permanent).
Pressing ► displays units of measure.
Overrun displays the amount of overrun volume detected after the 9900-1BC deactivates the batch relay,
triggering valve closure. Overrun resets each time a new batch starts.
Batch Count shows the number of batches which have run to at least 90% of completion. Press ► to
reset Batch Count.
Note:
If PWD REQUIRED is set to YES, you may be prompted to enter your password. PWD REQUIRED
setting can be changed in the OPTIONS menu.
Reset Count? Confi rmation screen for clearing the Batch Count. Press ▲ or ▼ to select YES and press
ENTER.
Customizable Label is the View name assigned to the 9900.
Default is BATCH for 9900-1BC.
Menu System