GF Signet 9900-1BC Batch Controller System - Manual (Page 14)

14 9900-1BC Batch Controller Manual
System Setup
ENTER
3s
Edit
Input Edit
Saves Changes
Input Edit Choices
(Password may
be required)
(Password may
be required)
or or
ENTER
or
ENTER
Select another
Menu Item
Return to
View Mode
Or
2x
+
Or
The menu is constructed in a loop,
so you can move forward and
backward to select an item. After
any item is edited, the display will
return to the selected item.
This basic operating procedure repeats throughout
the 9900 program:
1. Press ENTER for 3 seconds to enter EDIT menu.
2. Press ► to move to a specifi c menu item.
3. Press ENTER key to select the item for editing.
4. Press ▲ or ▼ to edit the value/selection.
5. Press ENTER to store the new value/selection.
6. Press ▲+▼ to select another menu item.
Repeat steps 3-5 as required.
7. Press ▲+▼ again to return to normal operation.
System Setup: Menu Navigation
NOTE: Example only. Your display may be different.
NOTE: The 9900 displays the
BATCH instrument type ONLY
if the Remote Batch Module is
installed.