Atec Agilent-J2300E - Manual (Page 66)

66
T1 (1.544 Mb/s) / E1 (2.048 Mb/s) J2298D
General
This interface module suitable for plugging into the J2300C/D/E Agilent Advisor
mainframe and the J2900A High Speed undercradle. This module has 4 bantam
connectors and two 8-pin connectors that can easily switch between RJ-48C
and RJ-45 pin wiring. The J2298D module handles frame- and cell- based
technologies such as ATM, Frame Relay, HDLC, SDLC, X.25, ATM DXI and PPP
in addition to BERT.
This module can be configured as a T1 (1.544 Mb/s) or as an E1 (2.048 Mb/s)
interface. For E1 information, see J2294D specifications.
Common to Inputs and Outputs:
Connectors:
Balanced 100 Ohm RJ-48C/RJ-45 and WECO mini-Bantams
Line Code:
ATM: B8ZS
WAN: B8ZS, AMI
Framing:
Extended Super Frame (ESF) with CRC
D4 (Super Frame)
Fractional WAN and ATM, any multiple of 56 kb/s or 64 kb/s channels
Unframed 1.544 Mb/s
Cell Mapping:
Direct (ITU-T G.804)
Cell Scrambling:
Conforms to ITU-TI.432.1 (x 43 + 1) and may be turned on or off
Inputs:
Two ports
Interface types (and input sensitivities):
DSX-1 (+6 dB to –10 dB)
Network Interface (+6 dB to -36 dB)
Received pulse amplitude measurement (mVpeak)
Monitor modes:
Terminated (100 Ohm)
Bridged (High Impedance)
Monitor Jack (20dB for T1)
Physical Layer Alarms and Statistics:
Loss of Signal (LOS)
Loss of Frame (LOF)
Alarm Indication Signal (AIS)
Remote Alarm Indication (RAI)/Yellow
Bi-polar violations
Extended Super-Frame (ESF) CRC errors
Line code violation
Frame slips
Frame bit errors
Pulse density violations / Excess zeros
Loss of Cell Delineation (LCD)
IMA Control Protocol (ICP) decoding supported
ATM Layer Statistics:
Auto-discovery of up to 1024 VCs and collection of statistics on each
Average utilization in percent
Instantaneous utilization in percent
Total cells received
Idle/unassigned cells received
Busy (assigned) cells received
Header (“HEC”) errors
ATM and WAN Interface
Specifications
(continued)