Atec Agilent-J2300E - Manual (Page 39)

39
Frame Relay UNI-User (CPE) Emulation
The UNI-User emulation follows the Frame Relay Forum Implementation
Agreement FRF.1.1 and ITU-T Q.933 Annex A. The UNI-User emulation
supports the following Standards in the following order:
• ITU-T Q.933 Annex A
• ANSI T1.617 Annex D
• Original Frame Relay Consortium (Original LMI)
The UNI-User emulation supports the following setups:
• FULL Status Polling Cycles (N391) in the range from 1 to 10 polling cycles, with
an N391 default value of 6 polling cycles.
• Status Enquiry messages (T391) counters, in the range from 1 to 60 seconds,
with a T391 default value of 10 seconds.
Frame Relay UNI-Network (Switch) Emulation
The UNI-Network emulation follows the Frame Relay Forum Implementation
Agreement FRF.1.1 and ITU-T Q.933 Annex A. The UNI-Network emulation
supports the following Standards in the following order:
• ITU-T Q.933 Annex A
• ANSI T1.617 Annex D
• Original Frame Relay Consortium (Original LMI)
The UNI-Network (Switch) emulation supports the following PVC Full Status
report message setups for up to 500 different PVC-DLCIs in a table format:
• Active / Inactive PVCs
• Present / New PVCs
• Deleted / Not deleted PVCs
Frame Relay NNI Emulation
The NNI emulation follows the Frame Relay Forum Implementation Agreement
FRF.2.1 The NNI emulation supports the following Standards in the following
order:
• ITU-T Q.933 Annex A
• ANSI T1.617 Annex D
• Original Frame Relay Consortium (Original LMI)
The NNI emulation supports the following setups:
• FULL Status Polling Cycles (N391) in the range from 1 to 10 polling cycles, with
an N391 default value of 6 polling cycles.
• Status Enquiry messages (T391) counters, in the range from 1 to 60 seconds,
with a T391 default value of 10 seconds.
The NNI emulation supports the following PVC Full Status report message
setups for up to 317 different PVC-DLCIs in a table format:
• Active / Inactive PVCs
• Present / New PVCs
• Deleted / Not deleted PVCs
Frame Relay (continued)