Atec Agilent-J2300E - Manual (Page 40)

40
Frame Relay Ping
A PING test verifies whether a route exists to any given IP address as depicted
in figure 21.
The Agilent Advisor provides static ping measurement capabilities by sending
IP-ICMP echo requests and then waiting for the ICMP echo reply from the
destination address.
The ping tests run with LMI emulation off or on for the following options:
•UNI-User Emulation
•UNI-Network Emulation
•NNI Emulation (bi-directional polling)
The test supports the following Frame Relay Standards:
•ITU-T Q.933 Annex A
•ANSI T1.617 Annex D
•Original Frame Relay Consortium (Original LMI)
PING without LMI can be selected
PING configuration selections are:
•Destination IP address
•Source IP address
•Layer 2 address or DLCI
•Number of ICMP data bytes (range between 1 and 1400)
•Number of requests
•Continuous or select between 1 and 9999 requests and specify time-out
(from 1ms to 10000ms)
•Encapsulation Ether type and RFC 1490/RFC 2427
Simulate mode can be either DTE or DCE
Figure 21: PING Measurement
Buffer Retransmission
The Agilent Advisor can capture a data file and then retransmit the frames back
to the network to replicate any particular network condition.
Frame Relay (continued)