Atec Agilent-J2300E - Manual (Page 49)

49
BRI – Basic Rate Interface Simulation/Call Placement Specifications
Simulate:
• TE (terminal equipment),
• NT (network termination), or
• LT (line termination)
Emulation:
• LAP-D and partial Q.931
Bus Configuration (for S/T interfaces):
• Point-to-Point, Short Passive Bus and Extended Passive Bus
• Handset Support - A-law and m-law on B1 or B2
Receiver Mode:
• Terminated or Bridged
BERT Channel:
• B1 - 56 kb/s or 64 kb/s
•B2 - 56 kb/s or 64 kb/s
•B1 and B2 - 112 kb/s or 128 kb/s
• B1 (B2 Looped) - Full Duplex (B1 transmit to B2 receive, B2 receive to B2
transmit, B2 transmit to B1 receive)
• B2 (B1 Looped) - Full Duplex (B2 transmit to B1 receive, B1 receive to
B1transmit, B1 transmit to B2 receive)
• B1 transmit to B2 receive
• B2 transmit to B1 receive
TE Simulation Tests:
• Place voice call
• Place 56 kb/s data call
• Place 64 kb/s data call
• Place BERT call
• B1 to B2 BERT Call - Place call and run a loopback BERT B1 to B2
• Answer call
NT Simulation Tests:
• Place voice call
• Place 56 kb/s data call
• Place 64 kb/s data call
Pre-written simulation test support:
• ETSI, NI-1, JT-Q.931, ITU-T, AT&T 5ESS, AT&T NI-1, DMS-100,
• 1TR6, VN4, Siemens, and Australia
ISDN (continued)