Atec Agilent-J2300E - Manual (Page 19)

19
STM-1/STM-1e/OC-3/EC-3
Loss of Signal (LOS) (*)
Loss of Frame (LOF) (*)
Loss of Pointer (LOP)
B1, B2, B3 BIP errors
Summary BIP error (*)
Label mismatch
MS-REI/REI-L (Line FEBE)
REI/REI-P (Path FEBE)
MS-RDI/RDI-L (Line/FERF)(*)
MS-AIS/AIS-L (*)
RDI/RDI-P (Yellow)
AIS/AIS-P
Summary Far End (RDI/RDI-P or
REI/REI-P) (*)
Loss of Cell Delineation (LCD) (*)
Remote
Optical power (STM-1/OC-3)
Pulse Amplitude (STM-1e/EC-3)
T1/DS1
Loss of signal (LOS) (*)
Loss of frame (LOF) (*)
Loss of PLCP sync (LOPS) (*)
AIS (*)
RAI/Yellow (X-bits) (*)
Bi-polar violations
ESF CRC errors
Line code violation (B8ZS)
Frame slips
Frame bits
One’s density
Excess zero’s
Loss of Cell Delineation (*)
Pulse Amplitude
E1
Loss of Signal (LOS) (*)
Loss of Frame (LOF) (*)
Line code violations (HDB3)
RAI (FERF) (*)
AIS (*)
CRC-4 errors (if CRC-4 is selected)
Frame alignment error
Loss of Cell Delineation (*)
Pulse Amplitude
J2
Loss of Signal (LOS) (*)
Loss of Frame (LOF) (*)
Line code violations (HDB3)
RAI (FERF) (*)
Payload AIS (*)
CRC-4 errors (if CRC-4 is selected)
Loss of Cell Delineation (*)
High Bit Error Ratio
ATM25
Loss of Signal (*)
Loss of Synchronization (*)
Timing sync frequency
Invalid Symbol
Short Cell
E3
Loss of signal (LOS) (*)
Loss of frame (LOF) (*)
BIP-8
Line code violations (HDB3)
Payload type mismatch
REI (FEBE)
RDI (FERF)
AIS (*)
Loss of cell sync (LOCS) (*)
Pulse Amplitude
T3/DS3
Loss of Signal (LOS) (*)
Loss of Frame (LOF) (*)
RDI (Yellow) (X-bits) (*)
AIS (*)
Line code violations (B8ZS)
REI (FEBE)
Idle (*)
P1/P2 parity errors
C-bit parity errors
PLCP sync loss (*)
PLCP Yellow (*)
PLCP BIP
PLCP FEBE
FEAC (*)
FEAC DS3 line
FEAC loss of signal/HBER
FEAC loss of frame
FEAC AIS
FEAC idle
FEAC service failure
FEAC no service failure
FEAC common equipment failure
FEAC line loopback activate
FEAC line loopback de-activate
Pulse Amplitude
ATM Testing (continued)