Franklin Fueling Systems TS 550 evo Fuel Management System Operators Guide - Manual (Page 39)

35
Displayed Alarm /
Warning
Device Description Recommended Actions
TPI Alarms
Capacitor Failing TPI The STP controller is reporting a
capacitor failure.
Refer to the applicable Smart controller Installation guide for details.
Clogged Intake TPI The STP controller has reported
a dry run condition but the
associated tank shows a product
level above the intake.
Ensure proper programming of the TPI and calibration of the Smart
Controller. If correct, check for an obstruction on the PMA.
Communication Failure TPI Communication from the TPI to
the STP controller has failed. The
Console is seeing the controller
but the controller is not responding
to commands.
Verify all wiring connections. Call FFS Technical Services Department
for support.
Controller Type Error TPI The programmed controller type
does not match what the console
is detecting.
Verify proper programming of the TPI as well as the Smart controller
type and address.
Dry Tank TPI The STP Controller has reported
a dry run condition and the
tank level is at or below the
programmed intake.
Ensure proper programming of the TPI and calibration of the Smart
Controller. If correct, add fuel.
Extended Run TPI The STP controller is reporting an
extended run condition.
Refer to the applicable Smart Controller Installation guide for details.
Hardware Fault TPI The STP controller is reporting
is reporting a hardware fault
condition.
High Temperature TPI The STP controller is reporting a
high temperature condition.
Locked Rotor TPI The STP controller is reporting a
locked rotor rating.
Not Calibrated TPI The STP controller is reporting
that it has not been calibrated.
Open Circuit TPI The STP controller is reporting an
open circuit condition.
Over Speed TPI The STP controller is reporting an
over speed condition.
Refer to the applicable Smart Controller Installation guide for details
Over Voltage TPI The STP controller is reporting an
over voltage condition.
Pump Communication Fail TPI Communication from the TPI to
the STP controller has failed.
Check all wiring connections and ensure that there is power supplied
to the Smart Controller.
Pump In Water TPI The water level has risen to within
3 inches of the programmed intake
level.
Ensure proper programming of the TPI and calibration of the Smart
Controller. If correct, have water removed from the tank
Relay Fault TPI The STP controller is reporting a
relay fault error.
Refer to the applicable Smart Controller Installation guide for details.
Short Circuit TPI The STP controller is reporting a
short circuit condition.
Unbalanced Load TPI The STP controller is reporting an
unbalanced load condition.
Unbalanced Voltage TPI The STP controller is reporting an
unbalanced voltage condition.
Under Voltage TPI The STP controller is reporting a
voltage level under 200VAC.
Under Load TPI The STP controller is reporting an
underload condition.
Unknown Fault TPI The STP controller is reporting an
unknown fault code.
Check fault condition on Smart controller and contact FFS Technical
Services for more information
Printer Alarms
Check Printer Printer Printer is out of paper, or the
printer door is open.
Make sure the printer has paper, and the printer door is closed
completely.
Printer Head
Temperature
Printer Print head high temperature
persists for at least 2 minutes
Printer will resume printing and the alarm will clear after a short cool-
down period. Keep the console area cool and ventilated. If the alarm
does not clear, contact FFS Technical Support.
Printer Motor
Temperature
Printer Printer motor has exceeded
temperature limit
Allow printer to cool. Keep the console area cool and ventilated. If the
alarm does not clear, contact FFS Technical Support.