Franklin Fueling Systems TS 550 evo Fuel Management System Operators Guide - Manual (Page 14)

10
Pump Status Summary Screen
This screen displays a graphical representation of the
submersible pumps, the name of the pump, and an
indication whether the pump is running or not. An alarm
condition on the pump is also indicated here, if present.
Pressing the print button while on this screen will print a
Pump Status Report for all Pumps.
To access the
Pump Status Summary screen select
Pumps from the Quick Jump Menu (QJM).
Pump Status Detail Screen
This screen provides a variety of information regarding the
pump and it settings. Information including: Pump Name,
Enabled/Disabled, Controller Type, Controller Address, the
tank the pump is installed in, and Pump Group. The screen
also includes status information such as Pump Running, has
the pump been forced off, and if a hook signal is present.
Pressing the print button while on the page will print a Pump
Status Report for just this tank.
Pump Controls feature can be accessed using the Control
Button on the Pump Status Detail Screen. This will allow
authorized users and technicians to reset the Pump
hardware and software.
Report Generator Screen
The Report Generator screen is used to create a variety of
reports. The report options available depend on software
options and system configuration. The available reports
include: Alarm History, Application Event History, Setup,
Inventory, Delivery, Tank Test, SCALD, Line Test, Pump
Status, Reconciliation, Regulatory, and Sensor Status.
To access the Report Generator screen select Reports
from the Quick Jump Menu (QJM).