Extron Electronics AVT 200HD User Guide - Manual (Page 60)

AVT 200HD Tuner • Remote Configuration and Control 54
Command
ASCII Command
(Host to Tuner)
Response
(Tuner to Host)
Additional Description
Other Settings (continued)
Show HDCP for output display
E O HDCP } X1!]
In verbose mode:
HDCPO X1!]
Show HDCP compliance X1! for
the display. For X1! :
0 = output connected with
encrypted input but not
HDCP compliant
1 = output connected with
encrypted input and HDCP
compliant
2 = No output connected
3 = Output connected, input
not encrypted or not
connected, output HDCP
status unknown
Executive Mode (Front Panel Lockout)
Enable executive mode 1
1X Exe1 ] Select executive mode 1: block
all front panel access (IR remote
control is available).
Enable executive mode 2 2X Exe2 ] Select executive mode 2: block
all front panel access except
volume control (IR remote control
is available).
Enable executive mode 3 3X Exe3 ] Select executive mode 3: block IR
remote control access only.
Disable executive mode 0X Exe0 ] Turn executive mode off.
View executive mode status X X1@] View current executive mode.
Information Requests
General information
I Tvtm X1) •Tvct X! . X@ •Sig X3!]
Show the currently selected
tuning mode (
X1) ), channel
( X! . X@ ) and signal strength level
( X3! ).
For X1) :
0 = tune mode.
1 = preset mode.
X! = 1–135; X@ = 1–99
X3! = 1–100%
Example: I Tvtm1 Tvct004.01 Sig042 ]
The AVT is in tune mode;
channel 4.1 is selected;
signal strength is 42%.
Query firmware version Q n.nn
In verbose mode:
Ver1*n.nn
]
Show the current firmware
version to two decimal places.
Query part number N 60-770-01 ]
In verbose mode:
Pno 60-770-01 ]
Show the unit part number.
Internal temperature E 20STAT } X1#]
In verbose mode:
Stat X1#]
Show the internal temperature in
degrees Fahrenheit.
X1# = +nnn.nn