Set output polarity – Extron Electronics AVT 200HD User Guide User Manual
Page 53
AVT 200HD Tuner • Remote Configuration and Control
47
Command
ASCII Command
(Host to Tuner)
Response
(Tuner to Host)
Additional Description
RF Input and Channel Selection (continued)
Presets (continued)
Name preset
EX2%,X2#NG}
Nmg
X2%
,
X2#]
Assign name
X2#
to preset
X2%
.
Command character is a comma.
Presets can have up to eight
characters.
NOTE:
The following characters are invalid in preset names:
~ @ =
`
[] {} <> ’ ‘ “ ” ; (semicolon) : (colon) | / \ ? and space.
Example:
E
2,NBC–LANG
}
Nmg2,NBC–LA
]
Name preset 2 “NBC–LA.”
View preset name
EX2%
NG
}
Nmg
X2%
,
X2#]
View the name of preset
X2%
.
NOTES:
•
If no preset is assigned to the
X2%
number that was entered, the name is shown as [unassigned].
•
If a channel preset is saved but not named, its default name is Presetnn.
•
If you try to name an unassigned preset, error code E11 is displayed.
•
If you try to recall a preset number to which no channel has been saved, error code E11 is displayed.
Channel Selection in Preset Mode
Select channel by preset
number
X2%
T
TvprR
X2%
*
X!.X@]
Select preset
X2%
(to select
channel
X!
.
X@
).
Increment preset
+T
TvprR
X2%
*
X!.X@]
Select the next preset number
in ascending order (to select
channel
X!
.
X@
).
Decrement preset
–T
––
TvprR
X2%
*
X!.X@]
Select the next preset number in
descending order.
Previous preset
0T
TvprR
X2%
*
X!.X@]
Return to the previously selected
preset.
View current preset
T
TvprR
X2%
*
X!.X@]
Show the current preset channel
name and number.
View physical channel for
current preset
*T
TvprR
X2%
*
X#]
Show current physical channel
X#
for preset
X2%
.
X#
= 1–135.
The physical channel number
corresponds to a 6 MHz
frequency range (see the
“Reference Information”
section).
Video Output
Set output resolution and rate
EX2^
RATE
}
Rate
X2^]
Select output resolution and
refresh rate
X2^
. For
X2^
:
0 = 480i @ 59.54 Hz
1 = 480p @ 59.94 Hz
2 = 720p @ 60 Hz
3 = 1080i @ 60 Hz
View output resolution and
rate
E
RATE
}
X2^]
Show the current output
resolution and refresh rate.
Set output polarity
EX2&
OPOL
}
Opol
X2&]
Set the polarity for the RGBHV
output.
View output polarity
E
OPOL
}
X2&]
Show the current output polarity
setting.
Select display aspect ratio
E
T
X%
ASPR
}
AsprT
X%]
Select output screen type
X%
.
For
X%
:
0 = 16x9
1 = 4x3
View display aspect ratio
E
TASPR
}
X%]
Show the current display type.