Extron Electronics AVT 200HD User Guide - Manual (Page 18)

AVT 200HD Tuner • Installation 12
3. Click Next . On the next screen, make sure that the Install the software
automatically (Recommended) radio button is selected, then click Next . (You do not
need to insert a disc.)
Figure 11. Selecting the Radio Button to Install the USB Driver Automatically
Your computer locates the driver needed for it to communicate with the AVT 200HD
via the USB port. This driver is loaded to the computer hard drive when the AVT
configuration program is installed.
4. When the Completed screen appears, click Finish to close the wizard.
NOTE: This wizard appears only the first time you connect the AVT to each USB
port. You do not see the wizard again unless you connect the AVT to a
different USB port on your computer.
5. Configure the AVT as desired, using SIS commands or the AVT 200HD Configuration
and Control Program (see the “
Using SIS Commands ” section for information on
available commands, or see the configuration and control program help file).