View broadcast flag – Extron Electronics AVT 200HD User Guide User Manual
Page 59
AVT 200HD Tuner • Remote Configuration and Control
53
Command
ASCII Command
(Host to Tuner)
Response
(Tuner to Host)
Additional Description
V-chip Setup (continued)
Set V-chip to block coarse
language (L) ratings
E
L
X3@
*
X2@
VCHP
}
VchpL
X2@]
Set L ratings
X2@
to be blocked
by the V-chip. For
X2@
:
0 = Unblock all ratings.
1 = Block L for TV-PG, TV-14,
and TV-MA.
2 = Block L for TV-14 and
TV-MA.
3 = Block L for TV-MA only.
View L rating block
E
L VCHP
}
X2@]
Show the L block setting.
Set V-chip to block sexual
situations (S) ratings
E
S
X3@
*
X2@
VCHP
}
VchpS
X2@]
Set S ratings
X2@
to be blocked
by the V-chip. For
X2@
:
0 = Unblock all ratings.
1 = Block S for TV-PG, TV-14,
and TV-MA.
2 = Block S for TV-14 and
TV-MA.
3 = Block S for TV-MA only.
View S rating block
E
S VCHP
}
X2@]
Show the S block setting.
Set V-chip to block violence
(V) ratings
E
V
X3@
*
X2@
VCHP
}
VchpV
X2@]
Set V ratings
X2@
to be blocked
by the V-chip. For
X2@
:
0 = Unblock all ratings.
1 = Block V for TV-PG, TV-14,
and TV-MA.
2 = Block V for TV-14 and
TV-MA.
3 = Block V for TV-MA only.
View V rating block
E
V VCHP
}
X2@]
Show the V block setting.
View current TV program
block
E
B VCHP
}
X1)]
In verbose mode:
VchpB
X1)]
Show block status
X1)
of the
current TV program. For
X1)
:
0 = not blocked
1 = blocked
View current TV program
rating
E
R VCHP
}
X3)]
In verbose mode:
VchpR
X1)]
Show rating
X3)
of the current
TV program.
X3)
is a string of up
to 16 characters.
Other Settings
Select TV standard
E
X$
TVST
}
Tvst
X$]
Set the TV format
X$
for the
incoming RF signal. For
X$
:
0 = over-the air
1 = cable standard
2 = cable HRC
3 = cable IRC
View TV standard
E
TVST
} ‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘
X$]
Show the current RF input.
View broadcast flag
E
I HDCP
}
X1)]
In verbose mode:
HDCPI
X1)]
Show status
X1)
of the broadcast
flag, which indicates that the
TV data stream contains HDCP
protected material. For
X1)
:
0 = flag off
1 = flag on