Installation, Installation overview – Extron Electronics AVT 200HD User Guide User Manual
Page 10
AVT 200HD Tuner • Installation
4
Installation
This section describes the rear panel of the AVT 200HD and provides instructions for cabling.
It covers the following topics:
• Installation Overview
• Rear Panel Features
• Control Connections
Installation Overview
Follow these steps to install and set up the AVT 200HD tuner:
1.
Disconnect power from the tuner and turn off all other devices that are connected to
it.
2.
(Optional) Mount the unit in a rack. Rack mount the tuner using the supplied
brackets (see the “
” in the “Reference Information” section).
3.
Connect the RF input. Connect an antenna or a CATV cable to the RF In F-type
connector (
j
4.
Connect the video output. Connect a television or other output device to one of
the following video output connectors:
•
VID — Composite video (
b
, top, on the
)
•
YC — S-video (
b
, bottom, on the
•
RGBHV — RGBHV (
c
)
•
Component video — YUVp/HD or YUVi (
d
on the
•
HDMI — HDMI digital (
e
5.
Connect the audio output. Connect a speaker set, amplifier, receiver, or other
audio output device to one or more of the following connectors:
•
RCA — Unbalanced analog (
f
)
•
Captive screw — Balanced or unbalanced analog (
g
on the
)
•
Coax — Digital S/PDIF (
h
•
Optical — (Fiber optic) Digital S/PDIF (
i
on the
)
6.
Connect control devices: Connect your computer to one of these AVT ports to
configure and control the tuner via the Windows
®
-based software or SIS commands.
•
RS232 port — Serial RS-232 control (
k
)
•
LAN Ethernet port — Ethernet control via Internet browser (
l
on the
)
•
Config port — USB connection (
b
“Operation” section)
7.
Connect power to the AVT by connecting a standard IEC power cord (provided) from
a 100 to 240 VAC, 50-60 Hz power source to the AC power receptacle (
a
).