Extron Electronics AVT 200HD User Guide - Manual (Page 34)

AVT 200HD Tuner • Operation 28
Unit Reset Menu (Resetting from the Front Panel)
Three modes of reset can be initiated from the AVT 200HD front panel.
Next
UNIT
RESET
FACTORY
RESET
PRESS NEXT
TO RESET
Next
Menu
• FACTORY RESET
• RESET USER SETTINGS
• CLEAR CH & PRESET LIST
VIEW
COMM SETTING
Next
RESETTING UNIT
PLEASE WAIT..
Menu
Default
Cycle
Turn either Adjustment knob
to select a reset mode.
Figure 24. Unit Reset Menu Flow
To reset the unit using the front panel menus:
1. Press the Menu button repeatedly until Unit Reset is displayed on the LCD screen.
2. Press Next to go to the Unit Reset submenu.
3. Rotate either Adjustment knob to display the reset options:
• Factory Reset : Restores all settings to the defaults that were set at the
factory except the IP settings. (This selection is equivalent to the SIS command
E ZXXX ; see the Total reset command in the “Command/response Table for SIS
Commands,” “Remote Configuration and Control” section.)
• Reset User Settings : Resets all settings except the scanned channels and presets.
• Clear Ch & Preset List : Erases scanned channels and presets.
4. When the desired reset option is displayed on the LCD screen, press Next. The LCD
screen displays
Press Next to Reset .
5. Press Next to start the reset. While the unit is being reset, the LCD screen displays
Resetting Unit Please Wait .
When the reset is complete, the LCD display returns to the default cycle if the channel
list has not been removed. If the channel list has been deleted, the
[Source] Channel
List Empty and Press Up Button to Start Scan messages alternate on the LCD
screen.
NOTE: You can perform resets using:
• The Reset button (see “ Resetting from the Rear Panel ,” later in this
section)
• SIS commands (see the Resets commands in the “Remote Configuration
and Control” section)
• The Windows-based control software (see the program help file)