YSI TruLab 1320P - Manual (Page 53)

TruLab pH/ISE 1320 Ion concentration
ba76157e01 03/2014
53
8.3 Selecting the measuring method
The following methods are supported:
 Standard addition
 Standard subtraction
 Sample addition
 Sample subtraction
 Blank value addition
1. Connect the ISE combination electrode to the meter.
The pH/ISE measuring window is displayed.
2. If necessary, select the ISE display (unit, mg/l) with .
3. If necessary, measure the temperature of the test sample with a ther-
mometer.
4. Open the ISE menu with
5. Thoroughly rinse the electrode with distilled water.
6. Adjust the temperature of the standard solutions.
7. Select Method with <> <> and confirm with
8. Select a method with <> <> and confirm with
9. Select Start method with <> <> and confirm with
Measurement with the selected method begins (see section 8.3.1
S
TANDARD ADDITION , page 54 ... section 8.3.5 S TANDARD ADDITION WITH
BLANK VALUE CORRECTION (B LANK VALUE ADDITION ), page 63).
Calibration
Man. temperature
: 25 °C
ISE setup
Method
: Standard addition
Start method
ISE
12.12.2012
12:12
Back