GE Industrial Solutions 6KCV300WPD - Manual (Page 55)

C h a n g i n g S e t t i n g s
The configuration of the actual project and Wm+Drive can be changed by dialogs that are opened from the
Options menu.
I Scheme Settings
The scheme settings dialog is opened by selecting Scheme Settings from the Options menu.
Figure 10.1.1: Set Scheme Dialog
The two lists include all schematics of the project. Each schematic will be either in the list of compound
blocks (left list) or of schemes (right list). Schemes are root schematics of the project (top level) while com-
pound blocks must be included in other schematics. By using the arrow keys each block can be put in one of
these two lists.
After selecting one of the schematics its name
be changed. This name is used in the status bar if the
mouse is over its icon in the block selection bar
Figure 10.1.2: Settings Dialog
4 5