GE Industrial Solutions 6KCV300WPD - Manual (Page 14)

GEI-100340
2.3 The Development Process
Figure 23.1: Design Flow
The total process for developing a application consists of the following steps:
1.
2 .
3 .
4 .
5 .
6 .
Create a new project.
Create the schematics by placing basic blocks and connecting them. This is done using the schematic
editor. If complex projects have to be created you can create compound blocks to insert
into your
project.
Generate code from the schematics and compile them for the PC as the target system.
Simulate the generated code on the PC for debugging. If errors are found go back to step 2. Change the
schematic, generate and compile once more and simulate again.
Generate code for the target system and compile it.
Run the compiled code on the target system.
4